Should I have replaced my water heater's shut-off gate valve with a ball valve? [solved]
I replaced my water heater's cold water shut-off gate valve with a ball valve...because the gate valve didn't close all the way and was dripping water while I was working (installing a sediment filter.)
I'm assuming that, since ball valves are superior to gate valves, pretty much every plumber would agree that doing this was a good thing, but if there are any professional plumbers present, I'm curious to know what your thoughts are.
I'm not a professional plumber (though I did work on water treatment systems for several years), but in my opinion what you did is fine.
Gate and globe (stop) valves are prone to corrosion and generally wear out over time. Ball valves are much more durable and reliable. I've seen many, many old stop valves that are leaking or don't shut off properly, or more often, leak as soon as you open/close them after they've not been touched for years. I can't say the same for ball valves - I've seen many that were installed for many years and still worked. I can even think of a couple where the outside looked totally corroded, and though it took a lot of force to turn (and sometimes a replacement handle), they still reliably shut without leaking.
On top of the reliability, the fact they use a 1/4 turn (instead of several full turns) and a quick glance tells you whether it's open or closed, ball valves are just vastly superior to gate and globe valves for almost all residential applications. Worth the extra dollar or so they cost.
The only thing they are not as good for is applications where you want to limit/control the flow rate (such as an outside tap or sample port). They can still do that, but are harder to finely adjust, and especially when one hasn't been opened for a long time and is a bit stiff, tend to suddenly give and open to full blast (I've been sprayed while trying to take water samples many times).
How To Fix A Main Water Shutoff Valve Leak
Answer this question
